StageTrix

Pedal Riser

$12.99

Most pedalboards have only one level and therefore require an awkward tap dance to access the second row of pedals without stomping on others accidentally. The Pedal Riser raises your second row of pedals to the perfect height, and has cable routing features that clean up your messy cables.

Easy to use
Just place on board, it holds tight
18-gauge steel
Attaches to both board and pedal via built-in heavy duty hook-and-loop fastener
Use two for double size pedals
Works with most pedalboards
Dimensions are 6.5″ × 4.25″ × 1″ high (16.5 cm x 10.8 cm x 2.6 cm high)

Pedal Fastener- 3 Pack

$7.99

The Pedal Fastener is a hook fastener designed specifically for attaching pedals to pedalboards. It features industrial strength adhesive optimized to stick to the rubber on the back of most pedals and hold fast up to 200 degrees Fahrenheit (93 degrees Celsius).

The optionally removable center preserves the specification sticker. Now players can move beyond over-sized rolls of low-quality generic fastener and attach pedals the professional way.

Optionally removable center area keeps pedals clean by preserving specification sticker
Economical 3-pack lets you attach your new pedals and replace lower quality fasteners on existing pedals
Use two for double size pedals
Dimensions are 2.25″ × 4.375″ (5.7 cm x 11.1 cm)

Setting Saver Pen

$4.99

Setting Saver™ - Keeps your gear dialed in.

The StageTrix Setting Saver had been originally announced during the 2012 NAMM Show in Anaheim California for late Spring release. In making sure all beta testing was completed, and striving for affordable recyclable packaging, we are finally ready to start shipping the Setting Saver™.

We have seen multiple ways for people to mark the settings on their amplifiers, effects pedals and mixing consoles, but non seemed easy and convenient. Everything now changes with the introduction of the Setting Saver™. A marker that applies a clean, bright fluorescent green ink to mark your settings. The ink is easily removed by wiping it off with your finger, and will not leave any markings when removed (use only on smooth, non-porus surfaces). Donnie Spada (guitar tech for No Doubt, The Offspring, 311) said this about the Setting Saver™: "Easy to read, easy to clean, no more pieces of tape or grease pens".

Perfect for amps, pedals, rack equipment, anything with knobs! No more loosing your settings when you transport your equipment.

Works great on consoles, equalizers, DJ gear, anything with sliders! Dial in a session, completely change it all, and than go back to the original settings in no time flat.